#Avrisp mkii programmer pinout full

The figure 1 and 2 show the pinouts for the 10-pin and 6-pin ISP connectors.ġ. Custom ISP Connector, Using 6-wire multicolour custom connector cable Standard 10-pin ISP Connector, Using 6-pin to 10-pin ISP cableģ. Sandard 6-pin ISP Connector, Using 6-pin ISP cableĢ. Depending on the existed connector on the target board, the cable has to be changed accordingly.ġ. The USB AVRISP XPII connects to the target board through 3 optional cables. Each USB AVRISP XPII has a unique ID, a PC could connects to several Devices at the same time

#Avrisp mkii programmer pinout full

Using PDIUSBD12, USB 1.1 (USB 2.0 Full Speed) 12Mbits/secondģ. Uses a USB interface for communication with the front-end software (Probably AVR Studio)Ģ. It takes only 2.5S to program a 12K program file with verification (programming speed was set to 1M while the Max speed could be up to 8M)ġ. High speed programs FLASH, EEPROM, Fuses, and Lock BitĢ. * Supports all the different voltages and speed grade versions of the devices listed in the table above.ġ. Refer to AVR Studio 6, the following devices are supported: Support for new devices will be added with new versions of AVR Studio. USB AVRISP XPII supports all AVR devices with ISP and PDI Interface. Supports the program files generated by IAR, ICCAVR, CVAVRġ. Firmware is upgradable to Support Future Devicesġ. AVR Studio 6 or WINAVR(GCC) is used as front-end softwareĢ. Identified as AVRISP mkII in AVRStudio, high speed programmingġ. Compatible with AT AVR ISP, easy to use, stable and reliableġ. 1. Supports all AVR devices with ISP or PDI interface, and certain 51 Devicesģ. Supports Fuses and Lock Bit ProgrammingĦ. Adjustable ISP programming speed up to 8M frequencyħ. USB 2.0 compliant (full speed, 12Mbps)ĩ. Powered from USB bus, does not require external power supplyġ.